Episode 4:

I would suggest gluing the chines in the opposite direction of that in the video: start at the bow and work toward the stern. This would allow getting the joint at the bow fitted more accurately, as there would be no tension on the chine. Also, the way the notches are cut in the formers, the chine will line up with the bottom, rather than the sides. This makes gluing the bottoms easier, but makes gluing the sides more difficult later, especially at the bow.

Episode 1: The Building Board
Episode 2: Building up the keel
Episode 3: Adding the formers and sheers
Episode 4: Adding the chines
Episode 5: Adding the bottom planks
Episode 6: Removing the hull from the building board
Episode 7: Adding the center deck
Episode 8: Adding the side decks
Episode 9 Adding the side planks
Episode 10: Trimming the side planks
Episode 11: Adding the rear deck
Episode 12: Filling and sanding the hull
Episode 13: Adding the cabin formers
Episode 14: Adding the fore cabin sides and tops
Episode 15: A workaround to a mistake made in Episode 13